Loctite 515 plane sealant anaerobic flange sealant instead of washer nut plane seal
Application:
Commonly used as in-place washers for pumps, thermostats, compressors, transmissions and safety locks, more suitable for rigid metal flanges, moderate curing speed, thixotropy.
Storage Conditions:
Conditions will be ideal if the product is stored in a cool, dry place in the temperature range of 8-28 ° C (46-82 ° C). To avoid contamination of unused glue, do not pour any glue back into the original package.
- 描述
- Global Tab
描述
LOCTITE 515 cures when confined in the absence of air
between close fitting metal surfaces. It seals close fitting joints
between rigid metal faces and flanges and will flex with minor
flange movements. Provides resistance to low pressures
immediately after assembly of flanges. Typically used as a
form-in-place gasket for pumps, thermostats, compressors,
transmission housings and axle covers
相关产品
-
LOCTITE AA 3106 UV curing adhesive UV curing acrylate adhesive
LOCTITE® AA 3106™ is primarily designed for bonding rigid or
flexible PVC to polycarbonate where large gap filling
capabilities and flexible joints are desired. The product has
shown excellent adhesion to a wide variety of substrates
including glass, many plastics and most metals. The thixotropic
nature of LOCTITE® AA 3106™ reduces the migration of liquid
product after application to the substrate. -
LOCTITE 609 designed for the bonding of cylindrical fitting parts
LOCTITE 609 is tested to the lot requirements of Military
Specification Mil-R-46082B. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification. -
LOCTITE 495 general purpose cyanoacrylate instant adhesive
Loctite 495 is High thermal performance and for rapid bonding of plastics, rubbers and metal. LOCTITE 495 is a general purpose cyanoacrylate instant adhesive.
-
Loctai 3623 one component transparent medical grade UV curing adhesive UV glue
Use guide
1. The product is photosensitive. Store and operate away from sunlight, ultraviolet and artificial light.
2. The product shall be dispensed with dispensing equipment with black feeding pipe.
3. For best results, the surface of the bonded material should be clean and free of grease.
4. The curing speed depends on the intensity of the light source, the distance from the light source, the curing depth, the bonding gap and the transmittance of the material..
5. For temperature sensitive bases, such as thermoplastics, cooling is required.
6 crystalline and semi-crystalline thermoplastics contact liquid glue need to check whether there is the possibility of stress cracking.
7. Excessive uncured adhesives can be removed by organic solvents (e.g. acetone).
8. The adhesive shall be cooled before bearing any load.
-
Loctite 3201 Light Cure Adhesive
Loctite® 3201™ is a nonfluorescing, high viscosity, UV/Visible light cure adhesive that forms very flexible joints with minimal streLoctite® 3201™ is a nonfluorescing, high viscosity, UV/Visible light cure adhesive that forms very flexible joints with minimal stress cracking. Ideal for bonding polycarbonate and other thermoplastics. ISO-10993 Biological Tested for medical device use.ss cracking. Ideal for bonding polycarbonate and other thermoplastics. ISO-10993 Biological Tested for medical device use.
