other

Directions for use

1. Clean the surface first, remove the dust, oil rust and so on. When the metal is followed, it is best to roughen first.

2. Open the front cover, and gently buckle the tip of the finger, so that there is no residual liquid, and then cut out the hole with scissors.

3. Drop a small drop of the agent in the face of the followed, immediately followed, and keep until hardened, then the area should not be too large, then the thickness of the layer should not exceed 0.2mm.

4. Wipe the container after use, and put the lid on, store in a cool and dry place or refrigerate.

Matters needing attention

Steps 1 Stimulate your eyes and instantaneously bond to your skin.

2 Contain cyanoacrylate to avoid touching eyes, mouth, fingers and skin. In case of any drop into the eye, wash the eye immediately with water for 15 minutes and seek medical treatment.

3 If it sticks to the skin, do not forcibly peel it off. Soak it in warm water or use acetone-based nail polish remover to clean it. Then carefully separate the bonded skin.

4. Keep out of reach of children.

ARON ALPHA PP Primer E is used to make polyolefin and other low surface energy plastics and elastomers suitable for bonding with ARON ALPHA cyanoacrylate (instant) adhesives.

Primers are effective on the following materials:
Polypropylene
Polyethylene
Polyolefin Plastic
Thermoplastic Rubber