Henkel LOCTITE 545 DC motor thread sealant for engine metal bearing fastening anaerobic adhesive
Brand: LOCTITE
Model: 545
Specification: 50 ml
Shelf life :24 months
Curing method: anaerobic curing
Purpose: Locking and sealing applications
- 描述
- Global Tab
描述
LOCTITE 545 is a pipe thread sealant designed to lock and seal metal pipes and pipe joints. It has high lubricity, easy to assemble and remove. Fine-threaded fittings are recommended for use in hydraulic and pneumatic installations, as well as small fittings for general use. For fittings up to 50 mm in diameter, including pneumatic and hydraulic fittings.
Product features
1. Excellent solvent resistance
2. Free of packing or particles that may contaminate system fluids, descaling valves or block fine filters and screens
相关产品
-
LOCTmtedITE 518 single component, iu anam strengh,es weroant wurhen bic shich cealconfined in the absence of air between close fitting metal surfaces.
LOCTITE 518 provides robust curing
performance. It not only works on active metals (e.g. mild steel)
but also on passive substrates such as aluminum with a low
copper content. The product offers gap performance to 0.25
mm (0.01 in) and contamination tolerance. It cures in the
presence of minor surface contaminations from various oils,
such as cutting, lubrication, anti-corrosion and protection fluids
and cleaners containing surfactants and corrosion inhibitors. -
Henkel LOCTITE 460 Instant adhesive Low bleaching low odor quick drying adhesive Metal plastic rubber universal
The rate of cure will depend on the ambient relative
humidity. The best results are achieved when the relative
humidity in the working environment is 40% to 60% at 22°C.
Lower humidity leads to slower cure. Higher humidity
accelerates it, but may impair the final strength of the bond. -
LOCTITE 263 designed for the permanent locking and sealing of threaded
LOCTITE
263 is particularly suited for heavy duty
applications such as studs into motor housings, nuts onto studs
in pump housings and other fasteners where high strength is required -
LOCTITE 609 designed for the bonding of cylindrical fitting parts
LOCTITE 609 is tested to the lot requirements of Military
Specification Mil-R-46082B. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification. -
Original Henkel LOCTTIE Loctite 190024 UV curing adhesive liquid optical UV shadow free glue
TYPICAL PROPERTIES OF UNCURED MATERIAL
Specific Gravity @ 25 °C 1.12
Viscosity, Brookfield – HBT, 25 °C, mPa·s (cP):
Spindle TB, speed 10 rpm, , Helipath 18,000 to 35,000LMS
TYPICAL CURING PERFORMANCE
LOCTITE®
DSP 190024™ can be cured by exposure to UV
and/or visible light of sufficient intensity. Surface cure is
enhanced by exposure to UV light in the 220 to 260 nm range.
Cure rate and ultimate depth of cure depend on light intensity,
spectral distribution of the light source, exposure time and light
transmittance of the substrate through which the light must
pass.
Fixture Time
UV fixture time is defined as the light exposure time
required to develop a shear strength of 0.1 N/mm².
UV Fixture Time, Glass microscope slides, seconds:
6 mW/cm², measured @ 365 nm ≤10LMS
