LOCTITE 104 two-component epoxy AB Structural glue thermosetting liquid adhesive
- Product parameters
Typical use: For bonding metals, glass, ceramics and thermosetting plastics in applications requiring extremely high temperature exposure.
Brand name: LOCTITE Ablestik 104
Component: two components
Product Overview:
Henkel Loctite Ablestik 104 is a two-component thermosetting liquid epoxy adhesive for the assembly of thermosetting plastics, metals, ceramics and glass. It has a long service life, high shear strength, non-conductivity, excellent high temperature and chemical resistance
- 描述
- Global Tab
描述
相关产品
-
LOCTITE271 designed for the permanent locking and sealing of threaded fasteners.
LOCTITE
271 designed for the permanent locking and
sealing of threaded fasteners. The product cures when
confined in the absence of air between close fitting metal
surfaces and prevents loosening and leakage from shock and
vibration. Typical applications include the locking and sealing
of large bolts and studs (up to M25 ).Specific Gravity 25 °C 1.1
Flash Point – See SDS
Viscosity, Brookfield – RVT, 25 °C, mPa·s (cP):
Spindle 1, speed 10 rpm, 400 to 600LMS -
LOCTITE 416 general purpose cyanoacrylate instant adhesive.
The rate of cure will depend on the bondline gap. Thin bond
lines result in high cure speeds, increasing the bond gap will
decrease the rate of cure. -
LOCTITE SF 7452 increased cure speed of LOCTITE cyanoacrylate adhesives
- Cures excess adhesive
- Provides excellent cosmetic appearance avoiding the white discoloration of instant adhesives
- Not recommended on plastics prone to stress cracking
-
Original Henkel LOCTTIE Loctite 190024 UV curing adhesive liquid optical UV shadow free glue
TYPICAL PROPERTIES OF UNCURED MATERIAL
Specific Gravity @ 25 °C 1.12
Viscosity, Brookfield – HBT, 25 °C, mPa·s (cP):
Spindle TB, speed 10 rpm, , Helipath 18,000 to 35,000LMS
TYPICAL CURING PERFORMANCE
LOCTITE®
DSP 190024™ can be cured by exposure to UV
and/or visible light of sufficient intensity. Surface cure is
enhanced by exposure to UV light in the 220 to 260 nm range.
Cure rate and ultimate depth of cure depend on light intensity,
spectral distribution of the light source, exposure time and light
transmittance of the substrate through which the light must
pass.
Fixture Time
UV fixture time is defined as the light exposure time
required to develop a shear strength of 0.1 N/mm².
UV Fixture Time, Glass microscope slides, seconds:
6 mW/cm², measured @ 365 nm ≤10LMS -
LOCTITE 638 designed for the bonding of cylindrical fitting parts, particularly where bond gaps can approach 0.25 mm
LOCTITE 638 is designed for the bonding of cylindrical
fitting parts, particularly where bond gaps can approach 0.25
mm and where maximum strength at room temperature is
requiredThe product cures when confined in the absence of air
between close fitting metal surfaces and prevents loosening
and leakage from shock and vibrationTypical applications
include locking bushings and sleeves into housings and on shaftsL
