LOCTITE 416 general purpose cyanoacrylate instant adhesive.
LOCTITE 416 is tested to the lot requirements of Military
Specification Mil-A-46050C. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification
- 描述
- Global Tab
描述
Cure Speed vs. Bond Gap
The rate of cure will depend on the bondline gap. Thin bond
lines result in high cure speeds, increasing the bond gap will
decrease the rate of cure.
相关产品
-
LOCTITE 480 rubber toughened adhesive with increased flexibility and peel strength along with enhanced resistance to shock.
LOCTITE 480 is a rubber toughened adhesive with
increased flexibility and peel strength along with enhanced
resistance to shock. -
Henkel LOCTITE M18 Metal loosening decontamination antirust bolt screw lubricant
Instructions
1.Shake the product can thoroughly before use.
2.Flip the attached metal straw up and spray at a distance of about 5-10cm with the metal straw onto area.
3.Repeat application twice or three times on rusted, corroded and seized parts and then knock the parts by a rubber hammer or sinilar tools lightly for best results.
4.Aiter use, flip the straw down and stored in cool and dry place.
-
LOCTITE 416 general purpose cyanoacrylate instant adhesive.
The rate of cure will depend on the bondline gap. Thin bond
lines result in high cure speeds, increasing the bond gap will
decrease the rate of cure. -
LOCTITE 609 designed for the bonding of cylindrical fitting parts
LOCTITE 609 is tested to the lot requirements of Military
Specification Mil-R-46082B. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification. -
Loctai 3623 one component transparent medical grade UV curing adhesive UV glue
Use guide
1. The product is photosensitive. Store and operate away from sunlight, ultraviolet and artificial light.
2. The product shall be dispensed with dispensing equipment with black feeding pipe.
3. For best results, the surface of the bonded material should be clean and free of grease.
4. The curing speed depends on the intensity of the light source, the distance from the light source, the curing depth, the bonding gap and the transmittance of the material..
5. For temperature sensitive bases, such as thermoplastics, cooling is required.
6 crystalline and semi-crystalline thermoplastics contact liquid glue need to check whether there is the possibility of stress cracking.
7. Excessive uncured adhesives can be removed by organic solvents (e.g. acetone).
8. The adhesive shall be cooled before bearing any load.
