LOCTITE 603 designed for the bonding of cylindrical fitting parts
Where cure speed is unacceptably long, or large gaps are
present, applying activator to the surface will improve cure speed
Where cure speed is unacceptably long, or large gaps are
present, applying activator to the surface will improve cure speed
- 描述
- Global Tab
描述
LOCTITE 603 is designed for the bonding of cylindrical fitting
parts, particularly where consistently clean surfaces cannot be
assuredThe product cures when confined in the absence of air
between close fitting metal surfaces and prevents loosening
and leakage from shock and vibrationTypical applications
include retaining roller bearings or oil impregnated bushings into housings
相关产品
-
LOCTITE AA 3106 primarily designed for bonding rigid or flexible
LOCTITE® AA 3106™ is primarily designed for bonding rigid or
flexible PVC to polycarbonate where large gap filling
capabilities and flexible joints are desired. The product has
shown excellent adhesion to a wide variety of substrates
including glass, many plastics and most metals. The thixotropic
nature of LOCTITE® AA 3106™ reduces the migration of liquid
product after application to the substrate. -
LOCTITE 403 low odor and low blooming properties for applications
Cure Speed vs. Bond Gap
The rate of cure will depend on the bondline gap. Thin bond
lines result in high cure speeds, increasing the bond gap will
decrease the rate of cure.
Cure Speed vs. Humidity
The rate of cure will depend on the ambient relative
humidity. The best results are achieved when the relative
humidity in the working environment is 40% to 60% at 22°C.
Lower humidity leads to slower cure. Higher humidity
accelerates it, but may impair the final strength of the bond.
Cure Speed vs. Activator
Where cure speed is unacceptably long due to large gaps,
applying activator to the surface will improve cure speed.
However, this can reduce ultimate strength of the bond and
therefore testing is recommended to confirm effect. -
LOCTITE 609 designed for the bonding of cylindrical fitting parts
LOCTITE 609 is tested to the lot requirements of Military
Specification Mil-R-46082B. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification. -
LOCTITE 263 designed for the permanent locking and sealing of threaded
LOCTITE
263 is particularly suited for heavy duty
applications such as studs into motor housings, nuts onto studs
in pump housings and other fasteners where high strength is required -
LOCTITE 416 general purpose ethyl-based instant adhesive
LOCTITE 416 is a transparent, colourless, high viscosity, general purpose ethyl-based instant adhesive. Suitable for metals, rubbers and plastic, it is also suitable for polyolefins in combination with Primer LOCTITE 770 or LOCTITE 7239. It has a fixture time of 20 – 40 secs.
