Loctite E-120HP Hysol High Performance Epoxy Adhesive, 50mL Dual Cartridge
- Brand name : Loctite
- Trade Name : Hysol®
- Series : LOC-E-120HP
- Item Name : Epoxy Adhesive
- Short Desc : EPOXY, 29353 E-120HP HYSOL 50ML DUAL CRT
- Packaging : 10/Case
- UPC : 00079340293533
- UNSPSC : 31201607
When fully cured, the epoxy offers superior thermal shock resistance, excellent mechanical and electrical properties and withstands exposure to a wide variety of solvents and chemicals.
- 描述
- Global Tab
描述
Henkel Loctite EA E-120HP is a high-viscosity, non-sag aerospace grade epoxy adhesive. Once fully cured it offers superior thermal shock resistance, excellent mechanical and electrical properties, and is able to withstand exposure to a wide variety of solvents and chemicals. 50 mL Cartridge.
相关产品
-
LOCTITE 480 rubber toughened adhesive with increased flexibility and peel strength along with enhanced resistance to shock.
LOCTITE 480 is a rubber toughened adhesive with
increased flexibility and peel strength along with enhanced
resistance to shock. -
LOCTITE 243 medium strength Threadlocking Adhesive
LOCTITE 243 is a general purpose threadlocker of medium bond strength. This threadlocker secures and seal bolts, nuts and studs to prevent loosening due to vibration. The product works on all metals, including passive substrates such as stainless steel, aluminum and plated surfaces.
-
LOCTITE 609 designed for the bonding of cylindrical fitting parts
LOCTITE 609 is tested to the lot requirements of Military
Specification Mil-R-46082B. Note: This is a regional approval.
Please contact your local Technical Service Center for more
information and clarification. -
LOCTITE 272 designed for the permanent locking and sealing of threaded fasteners.
LOCTITE
272 is designed for the permanent locking and
sealing of threaded fasteners. The product cures when
confined in the absence of air between close fitting metal
surfaces and prevents loosening and leakage from shock and
vibration. Typical applications include the locking and sealing
of large bolts and studs (M25 and larger).
TYPICAL PROPERTIES OF UNCURED MATERIAL
Specific Gravity 25 °C 1.11
Flash Point – See SDS
Viscosity, Brookfield – RVT, 25 °C, mPa·s (cP):
Spindle 4, speed 20 rpm 4,000 to 15,000 -
LOCTITE 403 low odor and low blooming properties for applications
Cure Speed vs. Bond Gap
The rate of cure will depend on the bondline gap. Thin bond
lines result in high cure speeds, increasing the bond gap will
decrease the rate of cure.
Cure Speed vs. Humidity
The rate of cure will depend on the ambient relative
humidity. The best results are achieved when the relative
humidity in the working environment is 40% to 60% at 22°C.
Lower humidity leads to slower cure. Higher humidity
accelerates it, but may impair the final strength of the bond.
Cure Speed vs. Activator
Where cure speed is unacceptably long due to large gaps,
applying activator to the surface will improve cure speed.
However, this can reduce ultimate strength of the bond and
therefore testing is recommended to confirm effect.
